PARKING BRAKE SWITCH > ON-VEHICLE INSPECTION |
for Preparation Click here
1. REMOVE PARKING BRAKE SWITCH ASSEMBLY |
Remove the screw and switch.
2. CHECK PARKING BRAKE SWITCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Switch Condition Specified Condition 1 - Switch body ground Parking brake switch ON (Switch pin released) Below 1 Ω Parking brake switch OFF (Switch pin pushed in) 10 kΩ or higher
3. INSTALL PARKING BRAKE SWITCH ASSEMBLY |
Install the switch with the screw.
- Torque:
- 0.9 N*m{ 9 kgf*cm , 8 in.*lbf }