NAVIGATION SYSTEM (for Navigation Receiver Type) > Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |
for Preparation Click here
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the display signal from an external device to the navigation receiver assembly via this circuit.WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the I67 navigation receiver assembly connector.
Disconnect the I204 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition I67-13 (VV+) - I204-6 (VV+) Always Below 1 Ω I67-14 (VV-) - I204-11 (VV-) Always Below 1 Ω I67-13 (VV+) - Body ground Always 10 kΩ or higher I67-14 (VV-) - Body ground Always 10 kΩ or higher I67-12 (SG) - Body ground Always 10 kΩ or higher
|
| ||||
OK | ||
|