CLUTCH UNIT (for Sedan) > INSPECTION



1. INSPECT CLUTCH DISC ASSEMBLY


C062956

  1. Using vernier calipers, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)
    If necessary, replace the clutch disc assembly.

  1. Install the clutch disc assembly onto the transaxle assembly.

    NOTICE:
    Insert the clutch disc assembly in the correct direction.


    D025257E13

  1. Using a dial gauge, measure the clutch disc assembly runout.

    Text in Illustration 
    *a
    		Transaxle Side

    Maximum runout:
    0.8 mm (0.031 in.)
    If necessary, replace the clutch disc assembly.


2. INSPECT CLUTCH COVER ASSEMBLY


D029069E01

  1. Using vernier calipers, measure the depth and width of the diaphragm spring wear.

    Maximum:
    A (Depth): 0.5 mm (0.020 in.)
    B (Width): 6.0 mm (0.236 in.)
    If necessary, replace the clutch cover assembly.


3. INSPECT FLYWHEEL SUB-ASSEMBLY


C062958

  1. Using a dial gauge, check the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.004 in.)
    If necessary, replace the flywheel sub-assembly.


4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


Q001060

  1. Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.

  1. Inspect the clutch release bearing assembly for damage and wear.

    HINT:
    If necessary, replace the release bearing assembly.