DTC U0155 Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) |
for Preparation Click here
DESCRIPTION
The ECM receives signals sent from the combination meter via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding ECU or sensor.DTC No. | DTC Detection Condition | Trouble Area |
U0155 |
|
|
MONITOR STRATEGY
Related DTCs | U0155: Verify communication |
Required Sensors/Components (Main) | ECM |
Required Sensors/Components (Related) | - |
Frequency of Operation | Continuous |
Duration | 2.9 seconds |
MIL Operation | Immediate |
Sequence of Operation | None |
TYPICAL ENABLING CONDITIONS
Monitor runs whenever following DTCs are not present | None |
Battery Voltage | 10.5 V or higher |
Ignition switch | ON |
Starter | OFF |
TYPICAL MALFUNCTION THRESHOLDS
Communication signal | Lost communication with combination meter |
CONFIRMATION DRIVING PATTERN
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure) (Click here).
- Turn the ignition switch off and wait for at least 30 seconds.
- Turn the ignition switch to ON and turn the Techstream on [A].
- Wait 5 seconds or more.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs [B].
- HINT:
- If a DTC is output, the system is malfunctioning.
- If a DTC is not output, perform the following procedure.
- Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
- Input the DTC: U0155.
- Check the DTC judgment result.
Techstream Display Description NORMAL - DTC judgment completed
- System normal
ABNORMAL - DTC judgment completed
- System abnormal
INCOMPLETE - DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
N/A - Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU's memory limit
- HINT:
- If the judgment result shows ABNORMAL, the system has a malfunction.
- DTC judgment completed
- If the test result is INCOMPLETE or N/A and no DTC is output, perform a universal trip and check for permanent DTCs (Click here).
- HINT:
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.
INSPECTION PROCEDURE
1.CHECK DTC OUTPUT (DTC U0155) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
Result Result Proceed to No output A U0155 B
|
| ||||
A | ||
|