AIR SWITCHING VALVE (for Bank 2) > INSPECTION |
for Preparation Click here
1. INSPECT AIR SWITCHING VALVE ASSEMBLY |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 3.0 to 7.4 Ω 1 - Body ground Always 1 MΩ or higher 2 - Body ground
Check the operation of the air switching valve.
Check that air does not flow from port A to port B.
- NOTICE:
- Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.
Apply battery voltage across terminals 1 and 2.
- NOTICE:
- When applying voltage, do not touch terminals 3, 4 and 5.
Check that air flows from port A to port B.
If the result is not as specified, replace the air switching valve.