AIR SWITCHING VALVE > REMOVAL |
for Preparation Click here
1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY |
Remove the exhaust manifold (Click here).
2. REMOVE INTAKE MANIFOLD |
Remove the intake manifold (Click here).
3. DISCONNECT NO. 1 WATER BY-PASS HOSE |
Disconnect the No. 1 water by-pass hose from the water by-pass joint and water inlet housing.
4. DISCONNECT NO. 2 WATER BY-PASS HOSE |
Disconnect the No. 2 water by-pass hose from the water by-pass joint.
5. DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY |
Remove the 3 bolts and disconnect the No. 2 water by-pass pipe.
6. REMOVE NO. 2 ENGINE COVER |
7. DISCONNECT FUEL TUBE CLAMP |
Disconnect the fuel tube clamp from the bracket.
8. REMOVE NO. 1 ENGINE COVER |
9. REMOVE FRONT WATER BY-PASS JOINT |
Disconnect the engine coolant temperature sensor connector.
Remove the 4 nuts, front water by-pass joint and 2 gaskets.
10. REMOVE AIR TUBE |
Disconnect the No. 2 and No. 3 hoses.
Disconnect the air pump connector.
Disconnect the air pump connector clamp's holder.
Using a clip remover, detach the wire harness claw.
Remove the 2 bolts and air tube.
Disconnect the 2 No. 1 air hoses from the air tube.
11. REMOVE AIR SWITCHING VALVE ASSEMBLY |
Disconnect the knock sensor connector.
Remove the bolt and bracket.
Disconnect the 2 air switching valve connectors.
Remove the 3 bolts and air switching valve.
12. REMOVE NO. 2 AIR TUBE |
Remove the 2 bolts, No. 2 air tube and gasket.
- NOTICE:
- Be careful not to damage the installation surface of the gaskets.
13. REMOVE NO. 3 AIR TUBE |
Remove the 2 bolts, No. 3 air tube and gasket.
- NOTICE:
- Be careful not to damage the installation surface of the gaskets.