SIDE MOULDING > INSTALLATION |
for Preparation Click here
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- When installing the moulding, heat the vehicle body and moulding using a heat light.
- Standard heating temperature:
Item Temperature Vehicle Body 40 to 60°C (104 to 140°F) Moulding 20 to 30°C (68 to 86°F)
- NOTICE:
- Do not heat the vehicle body and moulding excessively.
1. INSTALL LOWER NO. 1 SIDE PANEL MOULDING LH |
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
If reusing the moulding:
Clean the moulding.
Using a heat light, heat the moulding.
Remove the double-sided tape from the moulding.
Wipe off any tape adhesive residue with cleaner.
Apply new double-sided tape to the moulding, as shown in the illustration.
Install the moulding.
Using a heat light, heat the vehicle body and moulding.
Remove the peeling paper from the face of the moulding.
- HINT:
- After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the 2 clips to install the moulding.
- HINT:
- Press the moulding firmly to install it.