SHIFT LEVER ASSEMBLY (for Floor Shift Type) > REMOVAL |
for Preparation Click here
1. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
Detach the 6 claws and 3 clips, and remove the front door scuff plate.
2. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) |
Detach the 6 claws and 2 clips, and remove the rear door scuff plate.
3. REMOVE COWL SIDE TRIM BOARD LH |
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 9 clips and claw.
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
Detach the 12 clips and remove the console panel.
7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
Remove the clip.
Detach the 6 clips and remove the console panel.
w/ Trailer Towing System:
Disconnect the connector
8. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY |
Using a moulding remover, detach the 7 clips and remove the end panel.
except Regular Cab:
Detach the 2 wire harness clamps and disconnect the connector.
9. REMOVE CONSOLE BOX CARPET |
10. REMOVE REAR CONSOLE BOX ASSEMBLY |
Remove the 2 screws.
Detach the 2 wire harness clamps.
Remove the 4 bolts and rear console box.
11. REMOVE FRONT CONSOLE BOX |
Remove the 2 clips.
Remove the 6 screws and front console box.
12. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY |
Move the shift lever to the N position.
Disconnect the transmission control cable end from the shift lever.
Remove the clip and disconnect the transmission control cable from the shift lever retainer.
Disconnect the 2 connectors.
Remove the 4 bolts and floor shift.