FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


B166610E02
  1. Align the vehicle's claws with the seat belt retractor positioning holes.

  1. Install the seat belt with the 2 bolts.

    HINT:
    First install the bolt A, and then install bolt B.

    Torque:
    for bolt A:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }
    for bolt B:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


    B166847
  1. Connect the pretensioner connector as shown in the illustration.



    B166608
  1. Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


2. INSTALL CENTER PILLAR GARNISH
  1. Pass the front seat outer belt floor anchor through the center pillar garnish.

  1. Attach the claw to install the center pillar garnish.

  1. Install the 2 screws.

  1. Install the assist grip with the 2 bolts.



  1. Attach the 2 claws to install the 2 assist grip plugs.


    B165826



3. INSTALL LOWER CENTER PILLAR GARNISH


B165829
  1. Attach the 7 clips and 2 claws to install the pillar garnish.



    B165828
  1. Install the seat belt anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


    B165827
  1. Attach the 2 claws to install the cover.



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Install the front door opening trim weatherstrip.



5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
  1. Install the rear door opening trim weatherstrip.



6. INSTALL FRONT DOOR SCUFF PLATE


B165841
  1. Attach the 6 claws and 3 clips to install the front door scuff plate.



7. INSTALL REAR DOOR SCUFF PLATE


B165842
  1. Attach the 6 claws and 2 clips to install the rear door scuff plate.



8. INSTALL FRONT SEAT ASSEMBLY
  1. for Manual Seat:
    Install the front seat (Click here).

  1. for Power Seat:
    Install the front seat (Click here).



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).