REAR CRANKSHAFT OIL SEAL > INSTALLATION |
for Preparation Click here
1. INSTALL REAR CRANKSHAFT OIL SEAL |
Apply MP grease to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
- SST
- 09223-78010
- NOTICE:
- Keep the lip free from foreign matter.
- Do not tap the oil seal at an angle.
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
Using SST, hold the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
Install the front spacer, drive plate and rear spacer to the crankshaft.
Text in Illustration *1 Front Spacer *2 Drive Plate and Ring Gear *3 Rear Spacer Automatic Transmission Side - HINT:
- As the front spacer, the drive plate and ring gear and the rear spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.
Clean the bolts and bolt holes.
Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Text in Illustration *1 Adhesive
Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.
- Torque:
- 83 N*m{ 846 kgf*cm , 61 ft.*lbf }
- NOTICE:
- Do not start the engine for at least 1 hour after installation.
3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY |