OCCUPANT CLASSIFICATION ECU (for Separate Seat Type) > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT CLASSIFICATION ECU
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the battery negative (-) terminal is disconnected.

    CAUTION:
    After removing the cable from the terminal, wait for at least 90 seconds before starting the operation.
  1. Engage the claw and install the occupant classification ECU.

    NOTICE:
    1. If the occupant classification ECU has been dropped, or there are cracks, dents or other defects in the case or connector, replace it with a new one.
    2. When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.
  1. Connect the connector to the occupant classification ECU.



2. INSTALL FRONT SEAT ASSEMBLY RH


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


4. OCCUPANT CLASSIFICATION ECU INITIALIZATION


5. INSPECT SRS WARNING LIGHT
(Click here)