FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B087340E01
  1. Insert the 2 claws of the front shoulder belt anchor adjuster into the hole in the body and mount the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }


2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    B087293E03
  1. Check the amount of inclination required to lock the retractor.

    1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any directions. Also check that the belt locks when the inclination of the retractor is 45° or more.

      NOTICE:
      Do not disassemble the retractor.
      If operation is not as specified, replace the front seat outer belt.


    B087341E01
  1. Hook the lower stay of the retractor onto the 2 body hooks.

  1. Install the retractor with the bolt.

    Torque:
    8.5 N*m{ 85 kgf*cm , 75 in.*lbf }
  1. Connect the pretensioner connector as shown in the illustration.



    B087337E01
  1. Install the shoulder anchor with the nut.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }
  1. Check that the shoulder anchor rotates smoothly.



    B088586E01
  1. Install the floor anchor of the front seat outer belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }
  1. Check the ELR lock.

    NOTICE:
    1. The check should be performed with the front seat outer belt installed.
    2. Do not allow the anchor part of the front seat outer belt and the protruding parts of the floor panel to overlap.

    1. With the belt installed, check that the belt locks when it is pulled out quickly.
      If operation is not as specified, replace the front seat outer belt.

  1. Remove the bolt and floor anchor.



3. INSTALL CENTER PILLAR UPPER GARNISH
  1. Engage the clip and install the center pillar upper garnish.

  1. Tighten the 2 screws.



4. INSTALL CENTER PILLAR LOWER GARNISH
  1. Engage the 2 claws and 2 clips, and install the center pillar lower garnish.

  1. Install the floor anchor of the front seat outer belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }


5. INSTALL LAP BELT OUTER ANCHOR COVER


    B087415E01
  1. Engage the 3 claws and install the lap belt outer anchor cover.



6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP


    B087336E01
  1. Install the rear door opening trim weatherstrip.



7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP


    B087335E01
  1. Install the front door opening trim weatherstrip.



8. INSTALL REAR DOOR SCUFF PLATE
  1. Engage the 8 claws and install the rear door scuff plate.



9. INSTALL FRONT DOOR SCUFF PLATE
  1. Engage the 9 claws and install the front door scuff plate.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


11. INSPECT SRS WARNING LIGHT
(Click here)