PARKING BRAKE LEVER > INSTALLATION |
for Preparation Click here
1. INSTALL PARKING BRAKE SWITCH ASSEMBLY |
Install the parking brake switch with the screw.
- Torque:
- 0.88 N*m{ 9.0 kgf*cm , 7.8 in.*lbf }
2. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Connect the cable to the lever.
3. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY |
Install the parking brake lever (with the No. 1 parking brake cable) with the 2 bolts.
- Torque:
- 14.5 N*m{ 148 kgf*cm , 11 ft.*lbf }
Connect the No. 1 parking brake cable to the parking brake equalizer.
Temporarily install the wire adjusting nut and lock nut.
Connect the parking brake switch connector.
4. CHECK PARKING BRAKE LEVER TRAVEL |
Pull the lever upward with a force of approximately 200 N (20 kgf, 44 lbf) and count the number of clicks.
- OK:
- 6 to 8 clicks (without rear brake dragging)
5. ADJUST PARKING BRAKE LEVER TRAVEL |
Turn the No. 1 wire adjusting nut until the lever travel is correct.
- OK:
- 6 to 8 clicks (without rear brake dragging)
<Lever pulling force: approximately 200 N (20 kgf, 44 lbf)>
Tighten the lock nut.
- Torque:
- 6.0 N*m{ 61 kgf*cm , 53 in.*lbf }
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
- OK:
- 6 to 8 clicks (without rear brake dragging)
<Lever pulling force: approximately 200 N (20 kgf, 44 lbf)>
When operating the parking brake lever, check that the brake warning light illuminates at the first click.
- Standard condition:
- Brake warning light always illuminates at the first click.
6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY |
Install the rear console box (Click here).
- HINT:
- Refer to the procedures from the installation of the rear console box sub-assembly up until the installation of the No. 1 console upper panel garnish.
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |