FUEL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP WITH FILTER ASSEMBLY


    A288171E01
  1. Check the fuel pump resistance.

    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω
      If the result is not as specified, replace the fuel pump with filter assembly.
  1. Check fuel pump operation.

    1. Apply auxiliary battery voltage to terminals 1 and 2. Check that the pump operates.

      NOTICE:
      1. These tests must be done quickly (within 10 seconds) to prevent the coil from burning out.
      2. Keep the fuel pump as far away from the auxiliary battery as possible.
      3. Always switch the voltage on and off on the auxiliary battery side, not the fuel pump side.
      If the pump does not operate, replace the fuel pump with filter assembly.