STOP LIGHT SWITCH > ON-VEHICLE INSPECTION |
for Preparation Click here
1. INSPECT STOP LIGHT SWITCH ASSEMBLY |
Disconnect the A65 connector from the stop light switch assembly.
Measure the voltage according to the value (s) in the table below.
- Standard Voltage:
Tester Connection Condition Specified Condition A65-1 (B) - A65-3 (GND) Ignition switch off 11 to 14 V A65-5 (B) - A65-3 (GND) Ignition switch ON (IG) 11 to 14 V
If the result is not as specified, replace the stop light switch assembly.Text in IllustrationĀ *a Front view of wire harness connector
(to Stop Light Switch Assembly)
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition A65-3 (GND) - Body ground Always Below 1 Ī©
Reconnect the A65 connector to the stop light switch assembly.
Measure the voltage according to the value (s) in the table below.
- Standard Voltage:
Tester Connection Condition Specified Condition A65-2 (OUT) - A65-3 (GND) Power switch off, brake pedal not depressed Below 1 V A65-2 (OUT) - A65-3 (GND) Power switch off, brake pedal depressed 11 to 14 V A65-4 (L) - A65-3 (GND) Power switch on (IG), brake pedal not depressed Below 1 V A65-4 (L) - A65-3 (GND) Power switch on (IG), brake pedal depressed 11 to 14 V
If the result is not as specified, replace the stop light switch assembly.Text in IllustrationĀ *a Component with harness connected
(Stop Light Switch Assembly)