POWER WINDOW CONTROL SYSTEM > Jam Protection Function does not Operate

for Preparation Click here


DESCRIPTION

The jam protection function operates within a specified range during the manual up or auto up operation.

INSPECTION PROCEDURE

NOTICE:
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (Click here).
1.PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR)

  1. Initialize the power window regulator motor assembly LH (for driver door) (Click here).


NEXT


2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))

  1. Check if the power window auto up and down function operate normally (Click here).

    OK:
    Driver door auto up and down function is normal.


NG
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) (Click here)
OK


3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE

  1. Check if the jam protection function operates normally for the driver door power window.

    HINT:
    The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

    OK:
    Jam protection function operates normally.


NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR) (Click here)
OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)