DTC P1606-308 Collision has been detected or Collision Sensor Connection (Open) |
DTC P1606-317 Collision has been detected or Collision Sensor Connection (Open) |
for Preparation Click here
DESCRIPTION
The power management control ECU receives a signal that indicates a collision from the airbag sensor assembly to detect a collision. After detecting a collision, the power management control ECU shuts off the high voltage systems for safety.DTC No. | INF Code | DTC Detection Condition | Trouble Area |
P1606 | 308 | Collision detection A block signal is received from the airbag sensor assembly. (1 trip detection logic) |
|
317 | Collision detection Multiple wiring malfunctions occur simultaneously. (1 trip detection logic) |
|
- HINT:
- If P1606-308 or 317 is output, the vehicle cannot start unless the DTCs are cleared using the Techstream.
DTC No. | Data List |
P1606-308 |
|
P1606-317 |
INSPECTION PROCEDURE
- HINT:
- After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
- Turn the ignition switch to ON (IG) and wait for 5 seconds or more.
1.CHECK VEHICLE FOR COLLISION DAMAGE |
Check the vehicle condition.
- Result:
Result Proceed to The vehicle is not damaged. A The vehicle is damaged. B
|
| ||||
A | |
2.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
- Result:
Result Proceed to P1606 only is output. A P0A1D is output. B
Turn the ignition switch off.
|
| ||||
A | |
3.CHECK AIRBAG SYSTEM |
Troubleshoot the airbag system (Click here).
- Result:
Result Proceed to The system is normal. A There is a malfunction in the system. B
|
| ||||
A | |
4.CHECK INFORMATION CODE |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Access the freeze frame data of DTC P1606 and read the INF code.
- Result:
Result Proceed to INF code 308 is output. A INF code 317 is output. B
Turn the ignition switch off.
|
| ||||
A | ||
|
5.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
- Result:
Result Proceed to One or two of the following conditions are met. A All of the following conditions are met. B
DTC Output Status DTC P3107-213 or P3107-214 is output. DTC U0151-763 is output. DTC U0110-160 or U0110-657 is output.
Turn the ignition switch off.
|
| ||||
A | ||
|