DIFFERENTIAL VACUUM ACTUATOR > REMOVAL |
for Preparation Click here
1. REMOVE NO. 1 ENGINE UNDER COVER |
2. REMOVE NO. 2 ENGINE UNDER COVER |
3. DRAIN DIFFERENTIAL OIL |
for front differential:
Stop the vehicle on a level surface.
Using SST and the 10 mm straight hexagon wrench, 10 mm union nut wrench and socket adaptor, remove the differential filler plug and gasket.
- SST
- 09961-00950
Text in Illustration *1 10 mm Straight Hexagon Wrench *2 10 mm Union Nut Wrench *3 Socket Adaptor Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 65 N*m{ 660 kgf*cm , 48 ft.*lbf }
for rear differential:
Stop the vehicle on a level surface.
Remove the differential filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
4. REMOVE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY |
Remove the bolt and disconnect the differential breather tube bracket.
Support the differential with a jack.
Remove the No. 1 differential mounting nut.
Text in Illustration *1 Mounting Bolt *2 Mounting Nut
Remove the 2 mounting bolts and 2 nuts.
Lower the jack.
Disconnect the connector.
Remove the 4 bolts.
Using a hammer, pry out the actuator from the differential tube.