SIDE AIRBAG SENSOR (for Double Cab) > INSTALLATION

for Preparation Click here



1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    B214722
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  1. Install the side airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
  1. Check that there is no looseness in the installation parts of the side airbag sensor.

  1. Connect the connector.



2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
  1. Install the front seat outer belt assembly (Click here).