REAR DOOR BELT MOULDING > REMOVAL |
for Preparation Click here
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window) |
Using a moulding remover, detach the 2 clips and 2 claws and remove the rear power window regulator switch assembly with rear door armrest base panel.
Disconnect the connector.
2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
Insert a clip remover between the plate and trim board.
- HINT:
- Tape the clip remover tip before use.
Text in Illustration *1 Protective Tape
Turn the handle clockwise to remove the snap ring, rear door window regulator handle and plate.
3. REMOVE DOOR PULL HANDLE |
Remove the screw and door pull handle.
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
Remove the clip and screw.
Detach the 9 clips and remove the rear door trim board.
5. REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH |
Put protective tape around the rear door outer glass weatherstrip.
Text in Illustration *1 Protective Tape
Detach the 4 claws and remove the rear door outer glass weatherstrip.