VANE PUMP (for 1GR-FE) > INSTALLATION |
for Preparation Click here
1. INSTALL VANE PUMP ASSEMBLY |
Install the vane pump with the 2 bolts.
- Torque:
- 21 N*m{ 214 kgf*cm , 15 ft.*lbf }
Install the wire harness clamp bracket with the bolt.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Connect the oil pressure switch connector.
- NOTICE:
- Make sure that no oil adheres to the connector.
2. CONNECT PRESSURE FEED TUBE ASSEMBLY |
Install a new gasket onto the pressure feed tube.
Install the pressure feed tube with the union bolt.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
3. CONNECT OIL RESERVOIR TO PUMP HOSE |
Connect the hose with the clip.
4. INSTALL FAN AND GENERATOR V BELT |
While turning the belt tensioner counterclockwise, align its holes, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.
Install the V-ribbed belt.
While turning the belt tensioner counterclockwise, remove the bar.
If it is hard to install the V-ribbed belt, perform the following procedure.
Put the V-ribbed belt on everything except the P/S pump as shown in the illustration.
While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
6. PERFORM INITIALIZATION |
Perform initialization (Click here ).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
7. ADD POWER STEERING FLUID |
8. BLEED POWER STEERING FLUID |
9. CHECK FOR POWER STEERING FLUID LEAKAGE |