HEADLIGHT CLEANER CONTROL RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER CONTROL RELAY


    E186708E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    6 (PB) - 4 (E)
    		Battery voltage not applied
    		10 kΩ or higher
    Battery positive (+) → Terminal 3 (IG)
    Battery negative (-) → Terminal 4 (E)
    Battery negative (-) → Terminal 5 (FRWA)
    Battery positive (+) → Terminal 3 (IG)
    Battery positive (+) → Terminal 2 (H)
    Battery negative (-) → Terminal 4 (E)
    		Below 1 Ω for 0.8 to 0.9 seconds, and then resistance increases by large amount
    Battery positive (+) → Terminal 3 (IG)
    Battery positive (+) → Terminal 1 (HDLO)
    Battery negative (-) → Terminal 4 (E)
    Battery negative (-) → Terminal 5 (FRWA)
    If the result is not as specified, replace the headlight cleaner control relay.
    Text in Illustration 
    *a
    		Component without harness connected
    (Headlight Cleaner Control Relay)