ANTI-LOCK BRAKE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the Anti-lock Brake System (ABS).
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V
      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK AND CLEAR DTC*

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK FOR DTC*

          Result:
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B


        B.
        Go to step 9
        A


        7.PROBLEM SYMPTOMS TABLE

          Result:

          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        Go to step 9
        A


        8.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Terminals of ECU (Click here)

        2. Data List / Active Test (Click here)


        NEXT

        Go to step 10


        9.CHECK FOR FLUID LEAKAGE

          NEXT


          10.REPAIR OR REPLACE

            NEXT


            11.CONFIRMATION TEST

              NEXT

              END