DIFFERENTIAL OIL SEAL > REPLACEMENT

for Preparation Click here

1. Remove the drain plug and gasket to drain the ATF.
   

2. Install a new gasket and the drain plug.
   

   Torque:

   49 N*m{ 500 kgf*cm , 36 ft.*lbf }

1. Using SST, pull out the oil seal.
   

   SST

   09308-00010  
   

1. Using SST, pull out the oil seal.
   

   SST

   09308-00010  
   

1. Using SST and a hammer, install a new oil seal.
   

   SST

   09316-60011   (09316-00011)
   

   Oil seal installation depth:

   -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
   

2. Coat the lip of the oil seal with MP grease.
   

1. Using SST and a hammer, install a new oil seal.
   

   SST

   09649-17010  
   09950-70010   (09951-07150)
   

   Oil seal installation depth:

   -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
   

2. Coat the lip of the oil seal with MP grease.
   

HINT:

Drive the vehicle so that the engine and transaxle are at normal operating temperature.

Fluid temperature:

70 to 80°C (158 to 176°F)

1. Park the vehicle on a level surface and set the parking brake.
   

2. With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to S. Then return it to P.
   

3. Pull out the dipstick and wipe it clean.
   

4. Push the dipstick back fully into the pipe.
   

5. Pull the dipstick out again and check that the fluid level is within the HOT range. If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add a proper amount of new fluid and recheck the fluid level.