FUEL SENDER GAUGE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A183832E01

  1. Install the fuel sender gauge assembly by sliding it downward.

    NOTICE:
    Make sure that the fuel sender gauge arm does not bend.

  1. Connect the connector of the fuel sender gauge assembly.

    NOTICE:
    Do not damage the wire harness.


2. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

  1. Install the fuel suction tube assembly with pump and gauge to the fuel tank (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  1. Connect the cable to the negative battery terminal.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


4. INSPECT FOR FUEL LEAK

  1. Check fuel pump operation.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON and turn the Techstream on.

      NOTICE:
      Do not start the engine.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

    4. Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.

  1. Check for fuel leaks.

    1. There is no fuel leakage after performing maintenance anywhere on the fuel system. If there is a fuel leak, repair or replace parts as necessary.

  1. Turn the ignition switch off.

  1. Disconnect the Techstream from the DLC3.