NAVIGATION ECU > REMOVAL |
for Preparation Click here
1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
Disengage the 3 claws and clip, and then remove the lower instrument panel finish panel LH.
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH |
Disengage the 3 claws and clip, and then remove the lower instrument panel finish panel RH.
3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
Apply protective tape to the area shown in the illustration.
Insert a roof moulding remover and slide it toward the clip.
Pull the remover with both hands to disengage the clip as shown in the illustration.
Disengage the 2 claws and clip, and remove the instrument panel finish panel end LH.
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
Apply protective tape to the area shown in the illustration.
Insert a roof moulding remover and slide it toward the clip.
Pull the remover with both hands to disengage the clip as shown in the illustration.
Disengage the 2 claws and clip, and remove the instrument panel finish panel end RH.
5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY |
Disengage the 2 claws, 4 clips, and 2 guides.
w/ Occupant Classification System:
Disengage the clamp.
Disconnect each connector and remove the center instrument panel register assembly.
6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
Disengage the 4 clips and remove the center instrument cluster finish panel sub-assembly.
7. REMOVE RADIO AND DISPLAY RECEIVER WITH BRACKET |
Remove the 4 bolts.
Disconnect each connector and remove the radio and display receiver with bracket.
8. REMOVE NO. 2 RADIO BRACKET |
Remove the 5 screws and No. 2 radio bracket.
9. REMOVE NO. 1 RADIO BRACKET |
Remove the 5 screws and No. 1 radio bracket.
10. REMOVE EXTENSION MODULE |
Disconnect each connector.
Disconnect the connector to remove the extension module.