MANUAL TRANSAXLE ASSEMBLY > REMOVAL |
for Preparation Click here
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
- HINT:
- See the steps from "Discharge Fuel System Pressure" through "Remove Engine Assembly with Transaxle" (Click here).
2. INSTALL ENGINE HANGER |
Install the No. 1 and No. 2 engine hangers with new bolts as shown in the illustration.
- Torque:
- 38 N*m{ 387 kgf*cm , 28 ft.*lbf }
Item Part No. No. 1 engine hanger 12281-28010 No. 2 engine hanger 12282-28010 or 12282-AB010 Bolt 90080-10177
Using an engine sling device and a chain block, suspend the engine assembly with transaxle.
3. REMOVE FRONT ENGINE MOUNTING INSULATOR |
Remove the through bolt and nut, and separate the front engine mounting insulator.
4. REMOVE REAR ENGINE MOUNTING INSULATOR |
Remove the through bolt and separate the rear engine mounting insulator.
5. REMOVE STARTER ASSEMBLY |
Disconnect the terminal 50 connector from the starter assembly.
Remove the nut and disconnect the wire harness from terminal 30.
Remove the 3 bolts, clutch accumulator bracket, wire harness clamp bracket and starter assembly.
6. REMOVE MANUAL TRANSAXLE ASSEMBLY |
Remove the 6 bolts.
Remove the 4 bolts and the manual transaxle.
7. REMOVE ENGINE MOUNTING BRACKET LH |
Remove the 3 bolts and the engine mounting bracket LH.
8. REMOVE FRONT ENGINE MOUNTING BRACKET |
Remove the 3 bolts and the front engine mounting bracket.
9. REMOVE REAR ENGINE MOUNTING BRACKET |
Remove the 3 bolts and the rear engine mounting bracket.
10. REMOVE MANUAL TRANSMISSION CASE PROTECTOR |
Remove the 2 bolts and the manual transmission case protector.
11. REMOVE WIRE HARNESS CLAMP BRACKET |
Remove the bolt and wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket.