CYLINDER BLOCK > REPLACEMENT |
for Preparation Click here
1. REPLACE RING PIN |
- NOTICE:
- It is not necessary to remove the ring pin unless it is being replaced.
Remove the 12 ring pins.
Using a plastic hammer, install 12 new ring pins.
Text in Illustration *a Upper Side *b Lower Side *c Protrusion Height d 15 mm (0.591 in.) *e 14 mm (0.551 in.) *f 13 mm (0.512 in.) *g 12 mm (0.472 in.) - - - Standard Protrusion Height:
Item Specified Condition (A) 5.0 to 7.0 mm (0.197 to 0.276 in.) (B) 4.0 to 7.0 mm (0.157 to 0.276 in.)
2. REPLACE STRAIGHT PIN |
- NOTICE:
- It is not necessary to remove the straight pin unless it is being replaced.
Remove the 12 straight pins.
Using a plastic hammer, install 12 new straight pins.
Text in Illustration *a Front Side *b Rear Side *c LH Side *d Lower Side *e RH Side *f Protrusion Height *g 22 mm (0.866 in.) *h 10 mm (0.394 in.) *i 14 mm (0.551 in.) *j 6.0 mm (0.236 in.) - Standard Protrusion Height:
Item Specified Condition (A) 11.0 to 13.0 mm (0.433 to 0.512 in.) (B) 5.0 to 7.0 mm (0.197 to 0.276 in.) (C) 4.0 to 6.0 mm (0.157 to 0.236 in.)