DTC P05001F Vehicle Speed Sensor "A" Circuit Intermittent |
for Preparation Click here
DESCRIPTION
If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is controlling vehicle speed, the ECM determines that there is a momentary interruption or noise, and stores a DTC.DTC No. | DTC Detection Condition | Trouble Area |
P05001F | A momentary interruption or noise is detected when a rapid change of the vehicle speed occurs while the cruise control system is controlling vehicle speed. |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
- HINT:
- This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.
1.CHECK FOR DTCS (VEHICLE STABILITY CONTROL SYSTEM) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Check for DTCs.
- Result:
Result Proceed to DTC is not output A DTC is output B
|
| ||||
A | |
2.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly (Click here).
NEXT | |
3.CHECK FOR DTCS (CRUISE CONTROL SYSTEM) |
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
- HINT:
- If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control system operation is possible.
Turn the cruise control system on using the cruise control switch (ON-OFF button).
Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.
Check for DTCs (Click here).
- Result:
Result Proceed to DTC is not output A DTC P05001F is output B
|
| ||||
A | ||
|