DTC C1626 Steering Angle Sensor Failure |
for Preparation Click here
DESCRIPTION
This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.DTC No. | DTC Detection Condition | Trouble Area |
C1626 | A fail flag is transmitted from the steering sensor |
|
INSPECTION PROCEDURE
- NOTICE:
- If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
1.REPLACE STEERING SENSOR |
Replace the steering sensor with a new or known good one (Click here).
NEXT | |
2.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs and check that no DTCs are output (Click here).
- Result:
Result Proceed to DTC C1626 is output A DTC C1626 is not output B
|
| ||||
A | ||
|