DIFFERENTIAL OIL SEAL > REPLACEMENT |
for Preparation Click here
1. DRAIN AUTOMATIC TRANSAXLE FLUID |
Remove the front wheel opening extension pad LH, engine under cover LH and front fender apron seal LH.
Remove the refill plug and gasket from the automatic transaxle assembly.
Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle assembly.
Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle assembly.
Text in Illustration *1 No. 1 Transmission Oil Filler Tube *2 Hexagon Socket Wrench *a Overflow Plug Hole
Drain automatic transaxle fluid from the automatic transaxle assembly.
Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle assembly.
Text in Illustration *1 No. 1 Transmission Oil Filler Tube *2 Hexagon Socket Wrench *a Overflow Plug Hole - Torque:
- 1.7 N*m{ 17 kgf*cm , 15 in.*lbf }
Using a 6 mm hexagon socket wrench, install a new gasket and the overflow plug to the automatic transaxle assembly.
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf }
Temporarily install the gasket and refill plug to the automatic transaxle assembly.
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY |
3. REMOVE DRIVE SHAFT BEARING BRACKET |
Remove the 3 bolts and drive shaft bearing bracket.
4. REMOVE TRANSAXLE CASE OIL SEAL |
Using SST, tap out the transaxle case oil seal.
- SST
- 09308-00010
5. REMOVE FRONT TRANSAXLE CASE OIL SEAL |
Using SST, tap out the front transaxle case oil seal.
- SST
- 09308-00010
6. INSTALL TRANSAXLE CASE OIL SEAL |
Using SST and a hammer, tap in a new transaxle case oil seal.
- SST
- 09316-10010
09950-70010 (09951-07100)
- Oil seal driven in depth:
- -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
- NOTICE:
- Check that the oil seal is installed in the correct direction.
Coat the lip of the transaxle case oil seal with MP grease.
7. INSTALL FRONT TRANSAXLE CASE OIL SEAL |
Using SST and a hammer, tap in a new front transaxle case oil seal.
- SST
- 09316-60011
(09316-00011)
- Oil seal driven in depth:
- -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
- NOTICE:
- Check that the oil seal is installed in the correct direction.
Coat the lip of the front transaxle case oil seal with MP grease.
8. INSTALL DRIVE SHAFT BEARING BRACKET |
Install the drive shaft bearing bracket with the 3 bolts.
- Torque:
- 64 N*m{ 650 kgf*cm , 47 ft.*lbf }
9. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH |
Install a new front drive shaft hole snap ring LH.
- NOTICE:
- Face the end gap of the front drive shaft hole snap ring downward.
10. INSTALL FRONT DRIVE SHAFT ASSEMBLY |
11. ADD AUTOMATIC TRANSAXLE FLUID |