AIR FUEL RATIO SENSOR > INSTALLATION |
for Preparation Click here
- HINT:
- Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).
1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
Using SST, install the air fuel ratio sensor to the exhaust manifold RH.
Text in Illustration *a Fulcrum Length
30 mm (1.18 in.)*b Fulcrum Length
180 mm (7.09 in.)- SST
- 09224-00011
- Torque:
- without SST:
- 44 N*m{ 449 kgf*cm , 33 ft.*lbf }
- with SST:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf }
- NOTICE:
- The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 180 mm (7.09 in.) (Click here).
- The "with SST" torque value is effective when SST is parallel to the torque wrench.
- HINT:
- Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).
Connect the harness clamp.
Connect the air fuel ratio sensor connector.
2. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
3. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
Using SST, install the air fuel ratio sensor to the exhaust manifold LH.
Text in Illustration *a Fulcrum Length
30 mm (1.18 in.)*b Fulcrum Length
180 mm (7.09 in.)- SST
- 09224-00011
- Torque:
- without SST:
- 44 N*m{ 449 kgf*cm , 33 ft.*lbf }
- with SST:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf }
- NOTICE:
- The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 180 mm (7.09 in.) (Click here).
- The "with SST" torque value is effective when SST is parallel to the torque wrench.
- HINT:
- Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).
Connect the air fuel ratio sensor connector.
Install the wire harness clamp.
4. INSPECT FOR EXHAUST GAS LEAK |
5. INSTALL V-BANK COVER SUB-ASSEMBLY |
Fit the 3 retainers and install the V-bank cover sub-assembly.
6. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.