NAVIGATION RECEIVER (for TMC, TMMR Made) > INSTALLATION |
for Preparation Click here
1. INSTALL NAVIGATION RECEIVER ASSEMBLY |
2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY |
Engage the 4 clips to install the air conditioning control assembly.
3. INSTALL NO. 1 RADIO BRACKET |
Install the No. 1 radio bracket with the 4 screws.
4. INSTALL NO. 2 RADIO BRACKET |
Install the No. 2 radio bracket with the 4 screws.
5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY |
Connect each connector.
Engage the 6 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.
Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.
6. INSTALL FRONT CONSOLE UPPER PANEL GARNISH |
for Blank Type:
Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.
for 3 Switch Hole Type:
Connect each connector.
Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.
7. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY |
Connect the connector.
Engage the 4 clips to install the No. 2 instrument panel register assembly.
- NOTICE:
- When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.
8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.
9. INSTALL FRONT PANEL GARNISH RH |
Engage the 3 clips and 8 guides to install the front panel garnish RH.
10. INSTALL FRONT PANEL GARNISH LH |
Engage the 3 clips and 8 guides to install the front panel garnish LH.
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).