FRONT DOOR BELT MOULDING (for TMC, TMMR Made) > REMOVAL |
for Preparation Click here
1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
4. REMOVE FRONT DOOR SERVICE HOLE COVER |
Disconnect each connector.
Disengage the 4 clamps.
Remove the front door service hole cover.
- HINT:
- Remove any remaining butyl tape from the door.
5. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY |
Remove the grommet.
Connect the cable to the negative (-) battery terminal.
Connect the multiplex network master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the cable from the negative (-) battery terminal.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Disconnect the multiplex network master switch assembly.
Remove the 2 bolts.
- NOTICE:
- After the bolts are removed, do not allow the door glass to fall.
Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.
- NOTICE:
- Do not damage the door glass.
6. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY |
Put protective tape around the front door belt moulding assembly.
Text in Illustration *1 Protective Tape
Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.
Text in Illustration *1 Protective Tape