REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.


1. REMOVE REAR COMBINATION LIGHT PACKING


    E301909

  1. Remove the rear combination light packing.

    NOTICE:
    1. Be sure to remove all the traces of the old packing from the body.
    2. Do not reuse the removed packing. Be sure to install a new rear combination light packing to prevent water ingress.


2. REMOVE REAR COMBINATION LIGHT CORD


    E301910

  1. Disengage the clamp.

  1. Disconnect the connector to remove the rear combination light cord.



3. REMOVE REAR TURN SIGNAL LIGHT BULB


    E301911

  1. Turn the rear turn signal light socket with the rear turn signal light bulb as shown in the illustration, to remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.



4. REMOVE REAR BUMPER UPPER SIDE RETAINER


    E301913

  1. Using a screwdriver, disengage the claw and remove the rear bumper upper side retainer as shown in the illustration.