REAR STRUT ROD (for TMC, TMMR Made) > REMOVAL |
for Preparation Click here
- HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.
1. REMOVE REAR WHEEL |
2. REMOVE NO. 2 FLOOR UNDER COVER (for LH Side) |
for TMC Made:
Remove the screw and 2 clips.
Text in Illustration Nut (attached to under cover) Screw Disengage the 6 nuts and remove the No. 2 floor under cover.
- HINT:
- The 6 nuts will remain attached to the No. 2 floor under cover.
for TMMR Made:
Remove the 2 clips.
Text in Illustration Nut (attached to under cover) Disengage the 6 nuts and remove the No. 2 floor under cover.
- HINT:
- The 6 nuts will remain attached to the No. 2 floor under cover.
3. REMOVE NO. 1 FLOOR UNDER COVER (for RH Side) |
for TMC Made:
Remove the screw.
Text in Illustration Nut (attached to under cover) Screw Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.
- HINT:
- Rotate the clips to disengage them. The 5 nuts and 2 clips will remain attached to the No. 1 floor under cover.
for TMMR Made:
Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.
Text in Illustration Nut (attached to under cover) - HINT:
- Rotate the clips to disengage them. The 5 nuts and 2 clips will remain attached to the No. 1 floor under cover.
4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
Remove the bolt and separate the No. 3 parking brake cable assembly from the vehicle.
5. REMOVE REAR STRUT ROD ASSEMBLY |
Support the rear axle carrier sub-assembly with a jack using a wooden block.
Text in Illustration *1 Jack *2 Wooden Block
Remove the bolt, nut and separate the rear strut rod assembly (front side).
- NOTICE:
- When removing the bolt, keep the nut from rotating.
Remove the bolt, nut and rear strut rod assembly from the rear axle carrier sub-assembly.
- NOTICE:
- When removing the bolt, keep the nut from rotating.