STARTER > REMOVAL |
for Preparation Click here
1. PRECAUTION |
- NOTICE:
- After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3. REMOVE COOL AIR INTAKE DUCT SEAL |
Remove the 9 clips and cool air intake duct seal.
4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.
- NOTICE:
- When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.
5. REMOVE INLET AIR CLEANER ASSEMBLY |
Remove the 2 bolts and inlet air cleaner assembly.
6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE |
Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.
Disengage the ventilation hose clamp.
Disconnect the mass air flow meter sub-assembly connector.
Disengage the wire harness clamp.
Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.
Disengage the 2 air cleaner cap clamps and 2 guides.
Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.
7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
Disconnect the wire harness clamp.
Remove the 2 bolts and air cleaner case sub-assembly.
9. REMOVE BATTERY |
Loosen the nut, and disconnect the cable from the positive (+) battery terminal.
Loosen the nut, and remove the bolt and battery clamp.
Remove the battery and battery tray.
10. REMOVE STARTER ASSEMBLY |
Open the terminal cap.
Text in Illustration *1 Terminal Cap
Remove the nut and disconnect terminal 30.
Disconnect the starter assembly connector.
Remove the 2 bolts and starter assembly.