SHIFT LEVER > REMOVAL |
for Preparation Click here
Click here
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
2. REMOVE FRONT DOOR SCUFF PLATE LH |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH |
Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL |
Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
7. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.
8. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.
9. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY |
Disengage the 6 claws and the 3 clips, and then remove the floor shift position indicator housing sub-assembly.
with Seat Heater System:
Disconnect each connector.
10. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY |
Disengage the 3 claws and the 5 clips.
Disengage the clamp.
Disconnect the connector and remove the upper console rear panel sub-assembly.
11. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY |
Remove the 2 screws <F>.
Disengage the 4 claws.
Disconnect each connector and remove the instrument cluster finish panel center sub-assembly.
- HINT:
- Set the shift lever in the D position.
12. REMOVE CONSOLE BOX POCKET |
Remove the console box pocket.
13. REMOVE CONSOLE BOX CARPET |
Remove the console box carpet.
14. REMOVE CONSOLE BOX ASSEMBLY |
Remove the 2 screws <F>.
Remove the 2 bolts <G> and the console box assembly.
15. REMOVE NO. 2 CONSOLE BOX INSERT FRONT |
Remove the 3 screws <F>.
Disengage the clip and remove the No. 2 console box insert front.
16. REMOVE FLOOR CARPET BRACKET LH |
Release the clamp.
Turn back the floor carpet.
Remove the 3 clips.
Remove the floor carpet bracket LH.
17. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
Disconnect the end of the transmission control cable assembly from the shift lock control unit.
Disconnect the transmission control cable assembly from the shift lock control unit.
18. REMOVE SHIFT LOCK CONTROL UNIT |
Disconnect the shift lock control ECU connector and transmission control switch wire connector.
Remove the 4 bolts and shift lever.