ENGINE HOOD COURTESY SWITCH > REMOVAL



1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)


    B138886
  1. Remove the 7 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY (w/o Headlight Cleaner System)


    B140159E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedures for the RH side and LH side.


    B137735
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B137736
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.
  1. Disconnect each connector, and then remove the front bumper assembly.



3. REMOVE FRONT BUMPER ASSEMBLY (w/ Headlight Cleaner System)


    B137734E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedures for the RH side and LH side.


    B140161
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B140160
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.
  1. Disconnect each connector.



    B137737
  1. Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.



4. REMOVE HIGH PITCHED HORN ASSEMBLY


    E127996
  1. Disconnect the connector.

  1. Remove the bolt and the high pitched horn assembly.



5. REMOVE HOOD LOCK ASSEMBLY


    B146050
  1. Disconnect the connector.

  1. Remove the 3 bolts.



    B136827
  1. Disconnect the hood lock control cable.

  1. Remove the hood lock assembly.