DTC B2780 Push Switch / Key Unlock Warning Switch Malfunction |
for Preparation Click here
DESCRIPTION
This DTC will be output if the transponder key ECU assembly does not detect that the unlock warning switch is ON even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is ON when the ignition switch is ON.DTC No. | DTC Detection Condition | Trouble Area |
B2780 | "Unlock warning switch ON" is not detected when ignition switch is ON |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select Key SW in the DATA LIST and read the value displayed on the tester.
IMMOBILISER: Tester Display Measurement Item/Range Normal Condition Diagnostic Note Key SW Unlock warning switch signal/ON or OFF OFF: Key is in ignition key cylinder
ON: No key is in ignition key cylinder- - OK:
- ON (Key is in ignition key cylinder) appears on the screen.
|
| ||||
NG | |
2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Remove the unlock warning switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Switch Position Specified Condition 1 - 2 Switch pushed
(Key set)Below 1 Ω Switch free
(Key removed)10 kΩ or higher
|
| ||||
OK | |
3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Condition Specified Condition E22-2 - Body ground Always Below 1 Ω
|
| ||||
OK | |
4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH) |
Disconnect the E15 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Condition Specified Condition E15-3 (KSW) - E22-1 Always Below 1 Ω E22-1 - Body ground 10 kΩ or higher
|
| ||||
OK | ||
|