WATER PUMP > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE ENGINE UNDER COVER LH


4. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.



  1. Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.


    A136224E04

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


5. REMOVE FRONT FENDER APRON SEAL RH


6. REMOVE NO. 2 ENGINE MOUNTING STAY RH


    A134912

  1. Remove the 2 bolts and No. 2 mounting stay RH.



7. REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY


    A134909

  1. Remove the bolt and disconnect the ground cable.



    A134910

  1. Remove the 3 bolts and the engine moving control rod with bracket.



8. REMOVE NO. 2 ENGINE MOUNTING BRACKET RH


    A134911

  1. Remove the 3 bolts and No. 2 mounting bracket RH.



9. REMOVE V-RIBBED BELT


    A114351E03

  1. Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.

    SST
    09216-42010  

    NOTICE:
    1. Be sure to connect SST and the tools so that they are in line during use.
    2. When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
    3. After the tensioner is fully retracted, do not apply force any more than necessary.


10. REMOVE GENERATOR ASSEMBLY


    A135170

  1. Disconnect the generator connector.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Remove the bolt and wire harness clamp bracket.

  1. Remove the wire harness clamps.



    A133567

  1. Remove the 2 bolts and generator assembly.



11. REMOVE WATER PUMP PULLEY


A098715E03

  1. Using SST, remove the 4 bolts and water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)


12. REMOVE WATER PUMP ASSEMBLY


A094516E01

  1. Remove the clamp of the crankshaft position sensor from the water pump.

  1. Disconnect the wire of the crankshaft position sensor from the clamp bracket.



    B012052E03

  1. Remove the 4 bolts, 2 nuts and clamp bracket.



    A129792

  1. Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the contact surfaces of the water pump and cylinder block.