SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate |
for Preparation Click here
DESCRIPTION
When the driver seat belt is not fastened with the ignition switch ON, the driver seat belt warning light on the combination meter assembly comes on to inform the driver. The center airbag assembly detects the driver seat belt status and sends signals to the combination meter assembly using CAN.- NOTICE:
- The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK FOR DTCs |
Check for DTCs.
- Result:
Result Proceed to Output DTC (CAN communication system) A Output DTC (Airbag system) B No output DTC C
|
| ||||
|
| ||||
C | |
2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".
- METER:
Item Test Details Diagnostic Note D-BELT REMIND D-SEAT BELT indicator light (OFF/ON) Confirm that the vehicle is stopped with the engine idling
- OK:
- Switch condition (ON/OFF) can be switched by "ACTIVE TEST".
|
| ||||
OK | ||
|