POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > Rear Power Window Switch RH Circuit

for Preparation Click here


DESCRIPTION

This circuit supplies power to operate the power window regulator switch (Rear RH).

WIRING DIAGRAM


B137059E03


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (POWER WINDOW REGULATOR SWITCH - BATTERY AND BODY GROUND)


    B137048E03

  1. Disconnect the J1 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    3 (B) - Body ground
    		Ignition switch ON
    		10 to 14 V


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE