VALVE BODY ASSEMBLY > INSTALLATION |
for Preparation Click here
1. INSTALL MANUAL VALVE |
Install the manual valve to the valve body assembly.
2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
Install the spring and check ball body.
Align the groove of the manual valve with the pin of the lever.
Install the valve body with the 17 bolts.
- Torque:
- 11 N*m{ 110 kgf*cm , 8 ft.*lbf }
- NOTICE:
- Push the valve body against the accumulator piston spring and the check ball body to install it.
- First, temporarily tighten the bolts marked by (1) in the illustration because they are positioning bolts.
- Bolt length:
- Bolt A: 25 mm (0.984 in.)
Bolt B: 57 mm (2.244 in.)
Bolt C: 41 mm (1.614 in.)
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
Coat a new O-ring with ATF WS.
Install the O-ring to the oil strainer.
Install the oil strainer with the 3 bolts.
- Torque:
- 11 N*m{ 110 kgf*cm , 8 ft.*lbf }
4. INSTALL TRANSMISSION WIRE |
Coat the O-ring with ATF WS.
Install the ATF temperature sensor with the lock plate and bolt.
- Torque:
- 6.6 N*m{ 67 kgf*cm , 58 in.*lbf }
Connect the 7 shift solenoid valve connectors.
5. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
Install the 2 magnets in the oil pan.
Apply adhesive or equivalent to 18 bolts.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.
- Torque:
- 7.8 N*m{ 80 kgf*cm , 69 in.*lbf }
- NOTICE:
- Since the bolts should be seal bolts, apply adhesive to the bolts and tighten them within 10 minutes of application.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 6.9 N*m{ 70 kgf*cm , 61 in.*lbf }
7. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |
- HINT: