FRONT DOOR BELT MOULDING > REMOVAL |
for Preparation Click here
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH |
Disengage the 2 clips and remove the front door lower frame bracket garnish.
2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG |
Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.
3. REMOVE ASSIST GRIP COVER |
Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.
4. REMOVE COURTESY LIGHT ASSEMBLY |
Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.
Disconnect the connector.
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
Remove the 3 screws and clip (A).
Using a clip remover, disengage the 9 clips.
Pull up the front door trim board in the direction indicated by the arrow.
Disengage the reference bosses from the front door panel.
Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.
Disengage the 2 claws and disconnect the front door inside handle sub-assembly.
6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP |
Using a screwdriver, disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.
7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
Disconnect the connector.
Remove the 3 nuts.
Disengage the claw and remove the outer rear view mirror assembly.
8. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY |
Fully open the front door glass.
Put protective tape around the front door belt moulding assembly.
Using a moulding remover, disengage the 2 clips and 5 claws, and remove the front door belt moulding assembly.
- HINT:
- Tape the remover tip before use.
- NOTICE:
- Be careful when removing the moulding as there are claws attached to the front and rear ends of the moulding.